Table of Contents
Advertisement
Configuration
cable
Power
cable
Configuration
cable
Figure 86. Backplanes cable connection
Step 7.
Insert the hard disk drives and the filler panels into the bays.
Step 8.
Install the cover (see "Replacing the cover" on page 196).
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation"
on page 94.
Completing the installation
Use this information to complete the installation.
To complete the installation, complete the following steps:
Step 1.
If you removed the air baffle, reinstall it (see "Replacing the air baffle" on page 94).
Step 2.
If you removed the server cover, replace it (see "Replacing the cover" on page 96).
Step 3.
Install the server in the rack cabinet (see the Rack Installation Instructions that come with the
server for instructions).
Step 4.
Reconnect the cables and power cords (see "Connecting the external cables" on page 97).
Step 5.
Update the server configuration (see "Updating the server configuration" on page 98).
Step 6.
Slide the server back into the rack, if necessary.
Step 7.
Start the server. Confirm that it starts correctly and recognizes the newly installed devices, and
make sure that no error LEDs are lit.
Step 8.
(Business Partners only) Complete the additional steps in "Instructions for Business Partners"
on page 25.
Replacing the air baffle
Use this information to replace the air baffle.
94
Lenovo System x3650 M4 HD Installation and Service Guide
Mini-SAS cable
1.8-inch backplane assembly
Mini-SAS cable
1.8-inch backplane assembly
Power
cable
Mini-SAS cable
Power
cable
Backplane
connection
cable
Configuration
cable
Expander
Configuration
cable
Backplane
Power
cable
Advertisement
Table of Contents
Troubleshooting
