Installing The 8X2.5-Inch Hot-Swap Hdd Assembly Kit With Expander - Lenovo System x3650 M4 HD Installation And Service Manual

Step 6. Install the heat sink onto the microprocessor. See "Replacing a microprocessor and heat sink" on
page 287.

Installing the 8x2.5-inch hot-swap HDD assembly kit with expander

Use this information to add eight 2.5-inch hard-disk-drive bays in the server.
You can install an Lenovo System x3650 M4 HD Plus Eight 2.5-inch Hot-Swap HDD Assembly Kit
with Expander to add eight additional 2.5-inch hot-swap hard-disk-drive bays in the server. See
http://www.lenovo.com/ serverproven/ for a list of supported optional devices. To order a 8x2.5-inch
hot-swap HDD assembly kit with expander, contact your Lenovo sales representative or Lenovo reseller.
The 8x2.5-inch hot-swap HDD assembly kit with expander contains the following components:
• One expander
• One backplane connection cable
• Two screws
• One power cable
• One configuration cable
• Eight 2.5-inch HDD fillers
Note: The option including structural parts and Tier 1 parts.
To install the 8x2.5-inch hot-swap HDD assembly kit with expander, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 34.
Step 2. Remove the cover (see "Removing the cover" on page 37).
Step 3. Touch the static-protective package that contains the expander to any unpainted surface on the
outside of the server; then, grasp the expander and remove it from the package.
Step 4. Install the expander in the farthest slot from the power supplies.
80
Lenovo System x3650 M4 HD Installation and Service Guide