Table of Contents
Advertisement
Safety cover
Figure 129. 240 VA safety cover removal
Step 5.
Disconnect the hard disk drive backplane power cables from the connector in front of the safety
cover.
Step 6.
Slide the cover forward to disengage it from the system board, and then lift it out of the server.
Step 7.
If you are instructed to return the 240 VA safety cover, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Removing the power paddle card cover
Use this information to remove the power paddle card cover.
To remove the power paddle card cover, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 34.
Step 2.
Turn off the server, and disconnect all power cords and external cables.
Step 3.
Remove the cover (see "Removing the cover" on page 195).
Step 4.
Remove the screw from the power paddle card cover.
Screw
Chapter 6
.
Removing and replacing components
207
Advertisement
Table of Contents
Troubleshooting
