Table of Contents
Advertisement
Step 1.
Make sure that all cables, adapters, and other components are installed and seated correctly
and that you have not left loose tools or parts inside the server. Also, make sure that all internal
cables are correctly routed.
Before you slide the cover forward, make sure that all the tabs on the front, rear, and side of the
cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it will be
very difficult to remove the cover later.
Step 2.
Position the cover on top of the server.
Step 3.
Slide the cover toward the front of the server.
Step 4.
Make sure that the cover correctly engages all the inset tabs on the server.
Step 5.
Press down the blue latch on the top (in the center of the front of the server) of the cover.
Figure 89. Cover installation
Step 6.
Slide the server all the way into the rack until it latches.
Connecting the external cables
The following illustrations show the locations of the input and output connectors of the server.
The following illustrations show the locations of the input and output connectors on the front and rear of
the server.
Figure 90. Front view
Cover-release
2
latch
1
Video and USB
breakout connector
Chapter 2
.
Installing optional devices
97
Advertisement
Table of Contents
Troubleshooting
