Table of Contents
Advertisement
To remove the dual-port network adapter, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 34.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3.
Remove the cover (see "Removing the cover" on page 195).
Step 4.
Remove PCI riser-card assembly 2, if any (see "Removing a PCI riser-card assembly" on page 221).
Step 5.
Loosen the two captive screws on the network adapter from the screw holes on the system board.
Figure 161. Screws disengagement
Step 6.
Loosen the thumbscrew on the chassis.
Step 7.
Grasp the network adapter and disengage it from the pin, retention brackets, and the connector on
the system board; then, lift the adapter out of the port openings on the rear of the chassis and
remove it from the server.
236
Lenovo System x3650 M4 HD Installation and Service Guide
Retention
brackets
Captive screws
Thumbscrew
Pin
Advertisement
Table of Contents
Troubleshooting
