Table of Contents
Advertisement
To install a RAID adapter battery or flash power module in the server, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines"
on page 34.
Step 2.
Turn off the server and peripheral devices and disconnect all power cords and external devices.
Step 3.
Remove the cover (see "Removing the cover" on page 195).
Step 4.
Remove the cover (see "Removing the cover" on page 195).
Step 5.
Push the tab to open the cover on top of the air baffle.
Figure 125. Holder-cover open
Step 6.
Connect one end of the cable to the ServeRAID memory module.
Step 7.
Route the battery or flash power module cable along the chassis.
Attention: Make sure that the cable is not pinched and does not cover any connectors or obstruct
any components on the system board.
Step 8.
Install the battery or flash power module on top of the air baffle.
a.
Align the battery or flash power module cable connector with the slot on the holder. Place
the battery or flash power module into the holder and make sure that the holder engages
the battery or flash power module securely.
204
Lenovo System x3650 M4 HD Installation and Service Guide
Release tab
Advertisement
Table of Contents
Troubleshooting
