Modem Emulation; Table 10-8 Tunnel Modem Emulation Settings - Lantronix PREMIERWAVE XC HSPA+ User Manual

Using XML
Include in your file:


Modem Emulation

Some older equipment is designed to attach to a serial port and dial into a network with a modem.
This equipment uses AT commands to control the connection. For compatibility with these older
devices on modern networks, the PremierWave device mimics the behavior of the modem.
Tunnel Modem
Emulation Settings
Echo Pluses
Echo Commands
Verbose Response
Response Type
Error Unknown
Commands
Incoming Connection
Connect String
Display Remote IP
PremierWave® XC HSPA+ Intelligent Gateway User Guide
<configgroup name="tunnel disconnect" instance="1">

Table 10-8 Tunnel Modem Emulation Settings

Description
Set whether the pluses will be echoed back during a "pause +++ pause" escape
sequence on the Serial Line. Choices are:
Enabled

Disabled (default)

Set whether characters read on the Serial Line will be echoed, while the Line is in
Modem Command Mode. Choices are:
Enabled

Disabled (default)

Set whether Modem Response Codes are sent out on the Serial Line. Choices are:
Enabled

Disabled (default)

Select a representation for the Modem Response Codes sent out on the Serial
Line. Choices are:
Text (ATV1) (default)

Numeric (ATV0)

Set whether the Error Unknown Commands is enabled (ATU0) and ERROR is
returned on the Serial Line for unrecognized AT commands. Otherwise (ATU1) OK
is returned for unrecognized AT commands. Choices are:
Enabled

Disabled (default)

Set how and if requests are answered after an incoming RING (ATS0=2). Choices
are:
Disabled (default)

Automatic

Manual

Enter the customized Connect String sent to the Serial Line with the Connect
Modem Response Code.
Set whether the Display Remote IP is enabled so that the incoming RING sent on
the Serial Line is followed by the IP address of the caller. Choices are:
Enabled

Disabled (default)

10: Line and Tunnel Settings
79