Table of Contents
Advertisement
Network 2 Status
In the Network 2 status pages, you can view both the current interface operational settings as well
as the settings that would take effect upon a device reboot, as well as Link, QoS and Failover
status information.
To view Ethernet (wlan0) Interface status, click Network on the menu and select Network 2 -
> Interface -> Status.
To view Ethernet (wlan0) Link status, click Network on the menu and select Network 2 ->
Link -> Status.
To view Ethernet (wlan0) QoS status, click Network on the menu and select Network 2 ->
QoS -> Status.
Network 2 (Cellular "wwan0") Interface Settings
This page is used to view the status of the cellular interface on the device.
Note:
Statistics are as measured by the device since bootup. Your service provider may
account for data usage differently.
This page is used to configure the wwan0 interface on the device. To see the effect of these items
after a reboot, view the Status page.
Network 2 (wwan0)
Interface Settings
State
Priority
Connection Mode
Idle Timeout
Primary DNS
Secondary DNS
PremierWave® Intelligent Gateway User Guide
Table 6-6 Network 2 (wwan0) Interface Settings
Description
Select to enable or disable the interface.
It ranges from 0-10.
Note:
Lower priority number means higher preference.
The Always On connection mode keeps the device always connected to the
cellular network.
The On Demand connection mode leaves the link quiescent until an
application attempts to make use of the cellular network connection. Be aware
that in this mode, the first attempt to initiate a connection from the device
server may fail, since a new IP address may need to be negotiated.
The Shoulder Tap connection mode requires a short message (SMS) to make
the link active. See the SMS Inbound configuration for details on the message
syntax requirements.
If the connection mode is 'On Demand' or 'Shoulder Tap' and there is no network
activity for Idle Timeout duration the device will automatically disconnect from the
cellular network.
Enter the IP address of the primary Domain Name Server.
Note:
This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
Enter the IP address of the secondary Domain Name Server.
Note:
This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
6: Network Settings
44
Advertisement
Table of Contents
Need help?
Do you have a question about the PREMIERWAVE XC HSPA+ and is the answer not in the manual?
Questions and answers