To Configure Network 1 Interface Settings - Lantronix PREMIERWAVE XC HSPA+ User Manual

Network Interface
Settings (continued)
IPv6 State
IPv6 DHCP Client
IPv6 Address
IPv6 Default Gateway
IPv6 Domain
IPv6 Primary DNS
IPv6 Secondary DNS

To Configure Network 1 Interface Settings

Using Web Manager
To modify Ethernet (eth0) settings, click Network on the menu and select Network 1 ->

Interface -> Configuration.
Using the CLI
To enter the eth0 command level: enable -> config -> if 1

Using XML
Include in your file: <configgroup name="interface" instance="eth0">

PremierWave® Intelligent Gateway User Guide
Description
Select to enable of disable the IPv4 state.
Select to turn On or Off.
On: will provide an additional IPv6 address in addition to the displayed Link

Local IPv6 address and DHCPv6 IPv6 address. This is the auto configuration
address provided by the IPv6 router.
Off: will not display auto configured IPv6 address in CLI or Web UI.

Enter the static IPv6 address to use for the interface.
Note: This setting is used if Static IPv6 is active (DHCPv6 is Disabled). Changing
this value requires a reboot. When DHCPv6 is enabled, the XPort Pro Lx6 tries to
obtain an IPv6 address from a DHCPv6 server. If it cannot, then XPort Pro Lx6
generates and uses a Link local IPv6 address.
Enter the default IPv6 Default Gateway.
Enter the IPv6 domain name suffix for the interface.
Note: This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no Domain Suffix was acquired from the server.
Enter the IPv6 address of the primary Domain Name Server.
Note: This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
Enter the IPv6 address of the secondary Domain Name Server.
Note: This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
6: Network Settings
40