Table of Contents
Advertisement
Tunnel Disconnect
Mode Settings
Stop Character
Modem Control
Timeout
Flush Serial Data
To Configure Tunnel Disconnect Mode Settings
Using Web Manager
To configure the Disconnect Mode for a specific tunnel, click Tunnel in the menu and select
Tunnel 1 -> Disconnect Mode.
Using the CLI
To enter the Tunnel 1 Disconnect command level: enable -> tunnel 1 -> disconnect
Using XML
Include in your file:
Modem Emulation
Some older equipment is designed to attach to a serial port and dial into a network with a modem.
This equipment uses AT commands to control the connection. For compatibility with these older
devices on modern networks, our product mimics the behavior of the modem.
Tunnel Modem
Emulation Settings
Echo Pluses
PremierWave XC HSPA+ User Guide
PRELIMINARY DRAFT
Table 9-7 Tunnel Disconnect Mode Settings
Description
Enter the Stop Character which when received on the Serial Line, disconnects the
tunnel. The Stop Character may be designated as a single printable character or
as a control character. Control characters may be input in any of the following
forms: <control>J or 0xA(hexadercimal) or \10 (decimal). Disable the Stop
Character by blanking the field to set it to <None>.
Set whether Modem Control enables disconnect when the Modem Control pin is not
asserted on the Serial Line. Choices are:
Enabled
Disabled (default)
Enter the number of milliseconds a tunnel may be idle before disconnection. The
value of zero disables the idle timeout.
Set whether to flush the Serial Line when the Tunnel is disconnected. Choices are:
Enabled
Disabled (default)
<configgroup name="tunnel disconnect" instance="1">
Table 9-8 Tunnel Modem Emulation Settings
Description
Set whether the pluses will be echoed back during a "pause +++ pause" escape
sequence on the Serial Line. Choices are:
Enabled
Disabled (default)
PRELIMINARY DRAFT
9: Line and Tunnel Settings
53
Advertisement
Table of Contents
Need help?
Do you have a question about the PremierWave XC HSPA+ and is the answer not in the manual?