To Configure Gateway Dhcp Server Settings; Static Lease Listing; Routing Protocols; Table 6-17 Static Lease Listing - Lantronix PREMIERWAVE XC HSPA+ User Manual

To Configure Gateway DHCP Server Settings

Using Web Manager
To modify gateway DHCP server information, click Gateway on the menu and select

Configuration > DHCP Server.
Using the CLI
To enter the gateway command level: enable -> config -> gateway -> dhcp

server
Using XML
Include in your file: <configgroup name = "dhcp server">


Static Lease Listing

The device also provides the ability to pre-assign specific IP addresses to connected devices
using static leases. This would ensure that the connected device (identified by the MAC address)
always gets the same IP address even while using DHCP.
Static Lease List Settings
Delete
MAC Address
IP Address
IPv6 Address
Add a Static Lease Settings Description
MAC Address
IP Address
IPv6 Address
Add

Routing Protocols

The PremierWave XC HSPA+ intelligent gateway allows the configuration of routing protocols.
Routing protocols specify how routers communicate with each other, disseminating information
that enables the selection of routes between any two nodes on a computer network. Routing
algorithms determine the specific choice of route. Each router has a prior knowledge of networks
directly attached to it. A routing protocol shares this information among immediate neighbors first,
then through the network. This way, routers gain knowledge of the topology of the network. The
PremierWave device supports RIP and OSPF protocols.
PremierWave® Intelligent Gateway User Guide

Table 6-17 Static Lease Listing

Description
Click checkbox beside existing static lease MAC Address/IP Address to
delete, if available and if desired.
MAC Address of existing static leases are listed here.
Static IP Address of existing static leases are listed here.
Static IPv6 Address of existing static leases are listed here.

Table 6-18 Add a Static Lease

Enter the MAC Address of the static lease to be added.
Enter static IP address of the static lease to be added.
Enter static IPv6 address of the static lease to be added.
Click Add after adding new static lease information.
6: Network Settings
51