Table of Contents
Advertisement
Network Interface
Settings (continued)
Default Gateway
Hostname
Domain
DHCP Client ID
Primary DNS
Secondary DNS
MTU
To Configure Network Interface Settings
Using Web Manager
To modify Ethernet (eth0) settings, click Network on the menu and select Network 1 ->
Interface -> Configuration.
Using the CLI
To enter the eth0 command level: enable -> config -> if 1
Using XML
Include in your file: <configgroup name="interface" instance="eth0">
To View Network Interface Status
Using Web Manager
In Network Interface Status, you can view both the current operational settings as well as the
settings that would take affect upon a device reboot.
PremierWave XC HSPA+ User Guide
PRELIMINARY DRAFT
Description
Enter the IP address of the router for this network.
Note:
This setting will be used if Static IP is active (both DHCP and BOOTP
are Disabled).
Enter the hostname for the interface. It must begin with a letter or number,
continue with a sequence of letters, numbers, or hyphens, and end with a letter
or number.
Note:
This setting will take effect immediately, but will not register the
hostname with a DNS server until the next reboot.
Enter the domain name suffix for the interface.
Note:
This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no Domain Suffix was acquired from the server.
Enter the ID if the DHCP server requires a DHCP Client ID option. The DHCP
server's lease table shows IP addresses and MAC addresses for devices. The
lease table shows the Client ID, in hexadecimal notation, instead of the
PremierWave MAC address.
Enter the IP address of the primary Domain Name Server.
Note:
This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
Enter the IP address of the secondary Domain Name Server.
Note:
This setting will be used when either Static IP or Auto IP is active, or if
DHCP/BOOTP is active and no DNS server was acquired from the server.
When DHCP is enabled, the MTU size is (usually) provided with the IP address.
When not provided by the DHCP server, or using a static configuration, this
value is used. The MTU size can be from 576 to 1500 bytes, the default being
1500 bytes.
PRELIMINARY DRAFT
6: Network Settings
33
Advertisement
Table of Contents
Need help?
Do you have a question about the PremierWave XC HSPA+ and is the answer not in the manual?