Truss Mounting - High End Systems intellaspot XT-1 User Manual

CHAPTER 2
Setup and Configuration

Truss Mounting

When mounting the fixture on a truss or another type of support:
• Verify the truss or support will handle the combined weight of all the devices on the truss.
Each intellaspot XT-1 fixture weighs 52.2 kg (115 lb).
• Always mount an intellaspot XT-1 fixture using the mounting bracket assembly that shipped
with your fixture and a safety cable attached to the fixture's base.
WARNING!
Before mounting, disconnect power to the fixture. If it has been
operating, allow the fixture to cool for five minutes before handling.
CAUTION!
Do not use C- Clamps to mount the intellaspot XT-1 fixture to a truss.
Use the following steps to mount an intellaspot XT-1 fixture on a standard truss:
1. Due to its size and weight, at least two people should
support the fixture while another attaches clamps and
safety cables. Always stand on a firm, stable surface
when mounting the fixture to its support.
2. Tighten the clamps firmly to the fixture's base and to
the truss.
3. Run the safety cable through the loop on the fixture's
base, and around the truss.
10
Safety Cable Mount
intellaspot XT-1 User Manual
TM