Fieldfox Package Installer (Applies To N9912A Units With Serial Number Prefixes ≥5607); How To Run The Installer; How To Backup Files - Keysight N9923A User Manual

System Settings
FieldFox Package Installer (Applies to N9912A units with serial number prefixes ≥5607)
FieldFox Package Installer (Applies to N9912A units with serial
number prefixes ≥5607)
The FieldFox Package Installer enables you to download new versions of
firmware from either a USB memory or SD Card. Additionally, the Utility softkey
enables you to backup user files or restore user files.

How to run the Installer

Before running the Installer to update your firmware, you might want to
back up your user data. Refer to
— Press System 7.
— Then
— Then
— Then
— Then
— The Installer software opens after a couple of seconds.
If no files are displayed, verify that a USB memory or SD Card is installed
and press
— Then the
— Press
— "Current Step Progress:" bar and a "Total Progress:" bar are
— When the installation is completed, the FieldFox reboots.

How to backup files

This procedure backs up your user data to a USB or SD card. See also
restore files" on page
If you backup multiple versions of the user files, the FieldFox appends a
"_#" to each subsequently stored file. During restore, the file with the
highest appended number is loaded into the FieldFox.
From the initial Installer menu:
— Press
Keysight N9923-90001 User's Guide
System Configuration.
More
Firmware Update
Start Installer
Refresh List.
arrows or the knob to scroll to the firmware you want to
install.
Start Install
displayed along with this message: "Copying package. Do not
remove install media."
234.
Utility
"How to restore files" on page 234.
"How to
233