Switch> enable
Switch# exit
Switch>
Switch# configure
Switch(config)# interface gi1
Switch(config-if)#
4.4.5 line
Command:
line ( console | telnet | ssh )
Parameter:
console
telnet
ssh
Mode:
Global Configuration
Usage Guide:
Some configurations are line based. In order to configure these configurations, we need to enter Line Configuration
mode to configure them. Use "line" command to enter the Line Configuration mode and select the line to be
configured.
In Line Configuration mode, the prompt will show as "Switch(config-line)#"
Example:
This example shows how to enter Interface Configuration mode
Switch# configure
Switch(config)# line console
Switch(config-line)#
Select console line to configure.
Select telnet line to configure.
Select ssh line to configure.
Command Guide of WGSW-28040
69