Lldp - Planet WGSW-28040 Command Manual

4.13 LLDP

4.13.1 lldp
Command:
lldp
no lldp
Mode:
Global Configuration
Usage Guide:
The "lldp" command globally enable LLDP RX/TX ability. "no lldp run" command disables the LLDP RX/TX ability and
the behavior when receiving LLDP PDU would be decided by "lldp lldpdu" command. The LLDP enable status is
displayed by "show lldp" command.
Example:
The following example sets LLDP enable/disable.
Switch(config)# lldp
Switch# show lldp
State: Enabled
Timer: 30 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
LLDP packet handling: Flooding
Switch(config)# no lldp
Switch# show lldp
State: Disabled
Timer: 30 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
LLDP packet handling: Flooding
Command Guide of WGSW-28040
174