Dot1X Guest-Vlan - Planet WGSW-28040 Command Manual

Parameter:
<1-10>
Default:
2 times
Mode:
Interface Configuration
Usage Guide:
Use the "dot1x max-req" command to configure the maximum request retries. Use the no form of this command to
restore the period to default value.
Example:
The example shows how to configure maximum request retries to 4 times on port 1.
switch(config)# interface gi1
switch(config-if)# dot1x max-req 4
switch(config-if)# exit
switch(config)# show dot1x interfaces gi1
Port | Mode | Current State | Reauth Control | Reauth Period
--------+--------------------+----------------------+---------------------+-----------------
gi1 Authentication | Initialize | Enabled | 3600
Quiet Period: 60 Second
Supplicant timeout: 30 Second
Max req: 4
Session Time (HH:MM:SS): 0: 0: 0: 0

4.1.8 dot1x guest-vlan

Command:
dot1x guest-vlan <1-4094>
no dot1x guest-vlan
Parameter:
<1-4094>
Default:
Default is disabled
Specify the maximum request retries.
Specify VLAN ID to enable 802.1X guest VLAN.
Command Guide of WGSW-28040
28