Ip Igmp Snooping Static Group - Planet WGSW-28040 Command Manual

4.10.11 ip igmp snooping static group

Command:
[no] ip igmp snooping vlan <VLAN-LIST> static-group <ip-addr> interfaces
IF_PORTS
[no] ip igmp snooping vlan <VLAN-LIST> group <ip-addr>
show ip igmp snooping groups [(dynamic | static)]
clear ip igmp snooping groups [(dynamic | static)]
Parameter:
VLAN-LIST
ip-addr
IF_PORTS
Mode:
Global Configuration
Usage Guide:
'ip igmp snooping vlan 1 static-group 224.1.1.1 interfaces gi1' will add static group.
The static group will not learning others dynamic port. If the dynamic group exist, then the static group will overlap the
dynamic group. If remove the last member of static group, the static group will be delete.
The static group want to valid , must igmp snooping vlan enable and ip igmp snooping enable.
The configure can use 'show ip igmp snooping group [(dynamic | static)]' to display. And can use 'no ip igmp snooping
vlan 1 group 224.1.1.1' to delete the static group. Also can use 'clear ip igmp snooping groups' to delete the static
group.
Example:
The following example specifies that set ip igmp snooping static group test.
Switch(config)# ip igmp snooping vlan 1 static-group 224.1.1.1 interfaces gi1-2
Switch# show ip igmp snooping groups
VLAN | Gourp IP Address | Type | Life(Sec) | Port
------+------------------+--------+-----------+------------------
1 | 224.1.1.1 | Static| -- | gi1-2
Total Number of Entry = 1
Switch# clear ip igmp snooping groups static
specifies VLAN ID list to set
specifies multicast group ipv4 address
specifies port list to set or remove
Command Guide of WGSW-28040
149