Planet WGSW-28040 Command Manual page 297

no storm-control (broadcast | unknown-unicast | unknown-multicast)
storm-control (broadcast | unknown-unicast | unknown-multicast) level <0-1000000>
no storm-control (broadcast | unknown-unicast | unknown-multicast) level
Parameter:
broadcast
unknown-unicast
unknown-multicast
level <0-1000000>
Default:
Default broadcast storm control is disabled.
Default unknown multicast storm control is disabled
Default unknown unicast storm control is disabled
Default broadcast storm control rate is 10000.
Default unknown multicast storm control rate is 10000.
Default unknown unicast storm control rate is 10000.
Mode:
Interface Configuration
Usage Guide:
Storm control function is able to enable/disable on each single port. Use the "storm control" command to enable
storm control feature on the selected ports. And use "no storm control" command to disable storm control feature.
Not only port is able to enable/disable on the port. Each storm control type is also able to enable/disable on each
single port. Use the "storm-control (broadcast | unknown-unicast | unknown-multicast)" command to enable the
storm control type you need and use no form to disable it.
Each control type is allowed to have different storm control rate. Use "storm-control (broadcast | unknown-unicast
| unknown-multicast) level" command to configure it and use no form to restore to default value.
Example:
This example shows how to enable storm control on interface gi1.
Switch(config)# interface gi1
Switch(config-if)# storm-control
This example shows how to enable broadcast storm control and configure broadcast storm control rate to 200.
Switch(config)# interface gi1
Select broadcast storm control type
Select unknown unicast storm control type
Select unknown multicast storm control type
Specify the storm control rate for selected type
Command Guide of WGSW-28040
297