Lldp Med Tlv-Select - Planet WGSW-28040 Command Manual

gi3 | Yes | Yes | No | No | No
gi4 | Yes | Yes | No | No | No
gi5 | No | Yes | No | No | No
gi6 | No | Yes | No | No | No
gi7 | No | Yes | No | No | No
gi8 | No | Yes | No | No | No

4.13.12 lldp med tlv-select

Command:
lldp med tlv-select MEDTLV [MEDTLV] [MEDTLV] [MEDTLV]
no lldp med tlv-select
Parameter:
MEDTLV
Default:
lldp med tlv-select network-policy
Mode:
Interface Configuration
Usage Guide:
The command per port configures the LLDP MED TLV selection. "no lldp med tlv-select" command would remove all
selected MED TLV over the dedicated ports. It should be noticed that even no MED TLV is selected, MED capability
TLV would be attached if LLDP MED is enable. The configuration could be shown by "show lldp med" command.
Example:
This example sets port gi1-2 to select LLDP MED network policy, location, POE-PSE, inventory TLVs, and it sets port
gi3-4 to un-select all LLDP MED TLVs.
Switch(config)# interface range gi1-2
Switch(config-if)# lldp med tlv-select network-policy location poe-pse inventory
Switch(config-if)# exit
Switch(config)# interface range gi3-4
MED optional TLV. Available optional TLVs are : network-policy, location, poe-pse,
inventory.
Command Guide of WGSW-28040
185