Spanning-Tree Edge - Planet WGSW-28040 Command Manual

Default:
spanning-tree cost = 0
Mode:
Port Configuration
Usage Guide:
This command per port configures the STP port cost. The configuration could be shown by "show spanning-tree
interface" command.
Example:
This example sets port gi1 STP port cost to 100.
Switch# configure
Switch(config)# interface gi1
Switch(config-if)# spanning-tree cost 100

4.26.13 spanning-tree edge

Command:
spanning-tree edge
no spanning-tree edge
Mode:
Port Configuration
Usage Guide:
This command per port configures the STP edge port function. The configuration could be shown by "show
spanning-tree interface" command.
Example:
This example sets port gi1 STP edge port to enable.
Switch# configure
Switch(config)# interface gi1
Switch(config-if)# spanning-tree edge
Auto )
Command Guide of WGSW-28040
310