Link Aggregation; Lag Load-Balance - Planet WGSW-28040 Command Manual

4.12 Link Aggregation

4.12.1 lag load-balance

Command:
lag load-balance (src-dst-mac | src-dst-mac-ip)
Parameter:
src-dst-mac
src-dst-mac-ip
Default:
Default load balance algorithm is src-dst-mac
Mode:
Global Configuration
Usage Guide:
Link aggregation group port should transmit packets spread to all ports to balance traffic loading. There are two
algorithm supported and this command allow you to select the algorithm.
Example:
This example shows how to change load balance algorithm to src-dst-mac-ip.
Switch(config)# lag load-balance src-dst-mac-ip
This example shows how to show current load balance algorithm.
Switch# show lag
Load Balancing: src-dst-mac-ip.
Group ID | Type | Ports
---------+----------+----------------------------------------
1 | --------- |
2 | --------- |
3 | --------- |
4 | --------- |
Specify algorithm to balance traffic by using source and destination MAC address for all
packets.
Specify algorithm to balance traffic by using source and destination IP address for IP
packets and using source and destination MAC address for non-IP packets.
Command Guide of WGSW-28040
168