Planet WGSW-28040 Command Manual page 19

Configuring IP Address

3. On "WGSW-28040#" prompt, enter "configure".
On "WGSW-28040(config)#" prompt, enter the following command and press <Enter> as shown in Figure
4.
3-3.
WGSW-28040(config)# ip address 192.168.1.100 mask 255.255.255.0
WGSW-28040(config)# ip default-gateway 192.168.1.254
The previous command would apply the following settings for the Switch.
IP Address: 192.168.1.100
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.254
5. Repeat step 1 to check if the IP address is changed.
Figure 3-2: IP Information Screen
Figure 3-3: Configuring IP Address Screen
19
Command Guide of WGSW-28040