Errdisable Recovery Interval - Planet WGSW-28040 Command Manual

Usage Guide:
Port will be disabled by some invalid actions detected by protocols. Administrator can enabled these error disabled
port manually by "no shutdown" command in Interface Mode, or just turn on the auto recovery mechanism by this
command to auto enable the error disabled port after auto recovery interval.
Example:
This example shows how to enable auto recovery with reason bpduguard and broadcast-flood.
Switch(config)# errdisable recovery cause bpduguard
Switch(config)# errdisable recovery cause broadcast-flood
This example shows how to show current auto recovery state of each reason and port error disabled status.
Switch# show errdisable recovery
ErrDisable Reason | Timer Status
--------------------------+---------------
bpduguard | enabled
udld | disabled
selfloop | disabled
broadcast-flood | enabled
unknown-multicast-flood | disabled
unicast-flood | disabled
acl | disabled
psecure-violation | disabled
dhcp-rate-limit | disabled
arp-inspection | disabled
Timer Interval : 300 seconds
Interfaces that will be enabled at the next timeout:
Port | Error Disable Reason | Time Left
-----+----------------------------+------------

4.19.2 errdisable recovery interval

Command:
errdisable recovery interval <0-86400>
Command Guide of WGSW-28040
244