Switchport Hybrid Acceptable-Frame-Type - Planet WGSW-28040 Command Manual

switchport bybrid ingress-filtering
no switchport bybrid ingress-filtering
Mode:
Port Configuration
Usage Guide:
This command per port configures the ingress-filtering status. This filtering is used to filter the frames come from the
non-member ingress port. The configuration could be shown by "show interface switchport" command.
Example:
This example sets ingress-filtering to disable.
Switch# configure
Switch(config)# interface gi10
Switch(config-if)# switchport mode hybrid
Switch(config-if)# switchport hybrid ingress-filtering

4.29.6 switchport hybrid acceptable-frame-type

Command:
switchport hybrid acceptable-frame-type ( all | tagged-only | untagged-only )
Parameter:
all
tagged-only
untagged-only
Default:
switchport hybrid acceptable-frame-type = all
Mode:
Port Configuration
Usage Guide:
This command per port configures the acceptable-frame-type. The configuration could be shown by "show interface
switchport" command.
Specify to accept all frames
Specify to only accept tagged frames
Specify to only accept untagged frames
Command Guide of WGSW-28040
334