Protocol Vlan Binding; Show Protocol Vlan Group - Planet WGSW-28040 Command Manual

4.29.19 protocol vlan binding

Command:
vlan protocol-vlan group <1-8> vlan <1-4094>
no vlan protocol-vlan group <1-8>
Parameter:
<1-8>
<1-4094>
Mode:
Interface Configuration
Usage Guide:
Use the vlan protocol-vlan binding Interface Configuration mode command to binding protocol VLAN Group on
specified interfaces,
Use the no form of this command to cancel protocol VLAN Group Binding.
You can verify your setting by entering the show vlan protocol-vlan interfaces IF_PORTS Privileged EXEC
command
Example:
The following example how to configure Protocol VLAN function on specified interfaces.
Switch(config)# interface gi1
Switch(config-if)# vlan protocol-vlan group 1 vlan 2
Switch(config-if)# vlan protocol-vlan group 2 vlan 3

4.29.20 show protocol vlan group

Command:
show vlan protocol-vlan [group <1-8>]
Parameter:
<1-8>
Specify protocol vlan group to binding
Specifies the Proto VLAN ID to configure.
Specify protocol vlan group to display
Command Guide of WGSW-28040
343