Ip Dhcp Snooping Option Action - Planet WGSW-28040 Command Manual

Interface Configuration
Usage Guide:
Use the ip dhcp snooping option command to enable that insert option82 content into packet. Use the no form of
this command to disable.
Example:
The example shows how to enable option82 insertion. You can verify settings by the following show ip dhcp
snooping interface command.
switch(config)# interface gi1
switch(config-if)# ip dhcp snooping option
switch(config-if)# do show ip dhcp snooping interfaces gi1
Interfaces | Trust State | Rate (pps) | hwaddr Check | Insert Option82 |
------------+--------------+-------------+-------------------+-------------------+
gi1 | Untrusted | None | disabled | enabled |

4.6.11 ip dhcp snooping option action

Command:
ip dhcp snooping option action (drop|keep|replace)
no ip dhcp snooping option action
Parameter:
drop
keep
replace
Default:
DHCP snooping option82 is drop
Mode:
Interface Configuration
Usage Guide:
Use the ip dhcp snooping option action command to set the action when receive packets that with option82
content. Use the no form of this command to default setting.
Example:
The example shows how to set action to replace option82 content. You can verify settings by the following show
Drop packets with option82 that are received from un trusted port
Keep original option82 content in packet
Replace option82 content by switch setting
Command Guide of WGSW-28040
109