Ipv6 Mld Filter - Planet WGSW-28040 Command Manual

IPv6 mld profile index: 5
IPv6 mld profile action: deny
Range low ip: ff12::1
Range high ip: ff12::12
Switch(config-mld-profile)#exit
Switch(config)# exit
Switch# show ipv6 mld profile
IPv6 mld profile index: 1
IPv6 mld profile action: permit
Range low ip: ff13::1
Range high ip: ff13::10
IPv6 mld profile index: 5
IPv6 mld profile action: deny
Range low ip: ff12::1
Range high ip: ff12::12

4.17.10 ipv6 mld filter

Command:
ipv6 mld profile <1-128>
profile range ipv6 <ipv6-addr> [ipv6-addr] action (permit | deny)
show ipv6 mld profile [<1-128>]
Parameter:
<1-128>
[interfaces
IF_PORTS]
Mode:
Interface mode
Usage Guide:
After create ipv6 mld profile entry. Can use 'ipv6 mld filter 1' to bind a profile for port.
When then port bind a profile. Then the port learning group will update, if the group is not match the profile rule it will
remove the port from the group. Static group is excluded.
specifies profile ID
Specifies interfaces to display
Command Guide of WGSW-28040
228