Planet WGSW-28040 Command Manual page 55

[sequence <1-2147483647>] permit icmp (A.B.C.D/A.B.C.D|any) (A.B.C.D/A.B.C.D|any)
(<0-255>|echo-reply|destination-unreachable|source-quench|echo-request|
router-advertisement|router-solicitation|time-exceeded|timestamp| timestamp-reply|traceroute|any)
(<0-255>|any) [(dscp|precedence) VALUE]
[sequence <1-2147483647>] permit tcp (A.B.C.D/A.B.C.D|any) (<0-65535>|echo|
discard|daytime|ftp-data|ftp|telnet|smtp|time|hostname|whois|tacacs-ds|domain|www|
pop2|pop3|syslog|talk|klogin|kshell|sunrpc|drip|PORT_RANGE|any) (A.B.C.D/A.B.C.D|any)
(<0-65535>|echo|discard|daytime|ftp-data|ftp|telnet|smtp|time|hostname|whois|
tacacs-ds|domain|www|pop2|pop3|syslog|talk|klogin|kshell|sunrpc|drip|PORT_RANGE|any)
match-all TCP_FLAG] [(dscp|precedence) VALUE]
[sequence <1-2147483647>] permit udp (A.B.C.D/A.B.C.D|any)
(<0-65535>|echo|discard|time|nameserver|tacacs-ds|domain|bootps|bootpc|tftp|sunrpc|ntp|netbios-n
s|snmp| snmptrap|who|syslog|talk|rip|PORT_RANGE|any) (A.B.C.D/A.B.C.D|any)
(<0-65535>|echo|discard|time|nameserver|tacacs-ds|domain|bootps|bootpc|tftp|sunrpc|ntp|netbios-n
s| snmp|snmptrap|who|syslog|PORT_RANGE|any)[(dscp|precedence) VALUE]
no sequence <1-2147483647>
Parameter:
<1-2147483647>
(A.B.C.D/A.B.C.D|a
ny)
(A.B.C.D/A.B.C.D|a
ny)
[dscp VALUE]
[precedence
VLAUE]
icmp-type
icmp-code
igmp-type
l4-source-port
l4-destination-port
(Optional) Specify sequence index of ACE, the sequence index represent the priority of
an ACE in ACL.
Specify the source IPv4 address and mask of packet or any IPv4 address.
Specify the destination IPv4 address and mask of packet or any IPv4 address.
(Optional) Specify the DSCP of packet.
(Optional) Specify the IP precedence of packet.
Specify ICMP message type for filtering ICMP packet. Enter a type name of list or a
number of ICMP message type.
Specify ICMP message code for filtering ICMP packet.
Specify IGMP type for filtering IGMP packet. Enter a type name of list or a number of
IGMP type.
Specify TCP/UDP source port of for filtering TCP/UDP packet. Enter a port name of list
or a number of TCP/UDP port.
Specify TCP/UDP destination port of for filtering TCP/UDP packet. Enter a port name of
list or a number of TCP/UDP port.
Command Guide of WGSW-28040
55