Lldp Med Fast-Start-Report-Count - Planet WGSW-28040 Command Manual

Switch(config-if-range)# no lldp med tlv-select
Switch(config-if-range)# exit
Switch(config)# show lldp interfaces gi1-4 med
Port | Capabilities | Network Policy | Location | Inventory | POE
------ + ------------- + -------------- + -------- + ----------+ -----
gi1 | Yes | Yes | Yes | Yes | Yes
gi2 | Yes | Yes | Yes | Yes | Yes
gi3 | Yes | No | No | No | No
gi4 | Yes | No | No | No | No

4.13.13 lldp med fast-start-report-count

Command:
lldp med fast-start-repeat-count <1-10>
Parameter:
<1-10>
Default:
lldp med fast-start-repeat-count 3
Mode:
Global Configuration
Usage Guide:
The command globally configures the LLDP PDU fast start TX repeat count. When port links up, it will send LLDP
PDU immediately to notify link partner. The number of LLDP PDU sends when it links up depends on
fast-start-repeat-count configuration. The LLDP PDU fast-start transmits in interval of one second. The fast start
behavior works no matter LLDP MED is enabled or not. The configuration could be shown by "show lldp med"
command.
Example:
This example sets fast start repeat count to 10.
Switch(config)# lldp med fast-start-repeat-count 10
Switch(config)# show lldp med
Fast Start Repeat Count: 10
lldp med network-policy voice: auto
LLDP PDU fast start TX repeat counts.
Command Guide of WGSW-28040
186