Ipv6 Acl; Permit (Ipv6) - Planet WGSW-28040 Command Manual

4.3.7 ipv6 acl

Command:
ipv6 acl NAME
no ipv6 acl NAME
Parameter:
NAME
Mode:
Global Configuration
Usage Guide:
Use the ipv6 acl command to create an IPv6 access list and to enter ipv6-acl configuration mode. The name of ACL
must be unique that can not have same name with other ACL or QoS policy. Once an ACL is created, an implicit
"deny any" ACE created at the end of the ACL. That is, if there are no matches, the packets are denied. Use the no
form of this command to delete.
Example:
The example shows how to create an IPv6 ACL. You can verify settings by the following show acl command
Switch(config)#ipv6 acl ipv6test
Switch(ipv6-al)# show acl
IPv6 access list iptest

4.3.8 permit (IPv6)

Command:
[sequence <1-2147483647>] permit (<0-255>|ipv6) (X:X::X:X/<0-128>|any)
(X:X::X:X/<0-128>|any) [(dscp|precedence) VALUE]
[sequence <1-2147483647>] permit icmp (X:X::X:X/<0-128>|any)
(X:X::X:X/<0-128>|any) (<0-255>|destination-unreachable|packet-too-big|
time-exceeded|parameter-problem|echo-request|echo-reply|
mld-query|mld-report|mldv2-report|mld-done|
Specify the name of IPv6 ACL
Command Guide of WGSW-28040
59