Snmp Community - Planet WGSW-28040 Command Manual

Mode:
Global Configuration
Usage Guide:
The group version 1 and 2c only for snmp community use. And version 3 group only for snmp user use.
When group version is 1 or 2c , can only use noauth
The read/write/notify view must exist.
The configure use 'show snmp group' to check
Example:
The following example specifies that set snmp group test.
Switch(config)#snmp group group1 version 1 noauth read-view all write-viw ""
Switch(config)#snmp group group2 version 2c noauth read-view all write-view all
Switch(config)# snmp group group3 version 3 auth read-view all write-view all
Switch# show snmp group
Group Name Model Level ReadView WriteView NotifyView
----------------------- ------ ------ ------------- -------------- -------------
group1 v1 noauth all --- ---
group2 v2c noauth all all ---
group3 v3 auth all all ---

4.24.5 snmp community

Command:
snmp community NAME [view NAME] (ro|rw)
snmp community NAME group NAME
no snmp community NAME
Parameter:
community NAME
group NAME
[view NAME]
(ro|rw)
Snmp v1/v2 community name
Snmp community specifies access group name for advance mode
Snmp community specifies view for basic mode
Snmp community read or readwrite attribute for basic mode
Command Guide of WGSW-28040
286