Single Co Line Access - Panasonic KX-NS1000 Pc Programming Manual

10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
PC Programming Manual References
13.3.2 PBX Configuration—[5-3-2] Optional Device—Voice Message—DISA Message
10.7.1 PBX Configuration—[2-7-1] System—Class of Service—COS Settings—Manager—
Feature Guide References
2.28.2 Outgoing Message (OGM)

Single CO Line Access

Specifies the feature number used to make a trunk call using a certain trunk.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
PC Programming Manual References
18.1 PBX Configuration—[10-1] CO & Incoming Call—CO Line Settings
Feature Guide References
2.5.5.3 Trunk Access
Parallel Telephone (Ring) Mode Set / Cancel
Specifies the feature number used to set or cancel an SLT connected in parallel with a DPT to ring when
receiving an incoming call.
Note
This feature is restricted to extensions connected to legacy gateway PBXs. For information about
connecting SLTs and DPTs in parallel, refer to the documentation of the connected legacy gateway PBX.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
Maintenance Console Location
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main
Group Call Pickup
Specifies the feature number used to answer a call ringing at a certain call pickup group.
Value Range
Max. 4 digits (consisting of 0–9, *, and #)
442 PC Programming Manual
Manager