Panasonic KX-NS1000 Pc Programming Manual page 777

Maintenance Console Location
19.1 PBX Configuration—[11-1] Maintenance—Main
Communication—NL Code
Specifies the NL (New Line) code for the printer or personal computer.
If the printer or personal computer automatically feeds lines with a carriage return, select CR (Carriage Return).
If not, select CR + LF (Line Feed).
Value Range
CR + LF, CR
Maintenance Console Location
19.1 PBX Configuration—[11-1] Maintenance—Main
Feature Guide References
2.22.1.1 Station Message Detail Recording (SMDR)
Communication—Word Length
Specifies the number of bits in each byte of a character.
When connecting the Maintenance Console to the PBX using an RS-232C cable, assign the following values
to the Serial Interface (RS-232C) port of the PBX:
Word Length: 8 bit, Parity Bit: None, Stop Bit: 1 bit
Notice
Do not use the following combinations:
•
Word Length: 8 bit, Parity Bit: Space, Stop Bit: 1 bit
•
Word Length: 8 bit, Parity Bit: Mark, Stop Bit: 2 bit
•
Word Length: 8 bit, Parity Bit: Space, Stop Bit: 2 bit
Value Range
7 bit, 8 bit
Maintenance Console Location
19.1 PBX Configuration—[11-1] Maintenance—Main
Feature Guide References
2.22.1.1 Station Message Detail Recording (SMDR)
Communication—Stop Bit
Selects a stop bit code that indicates the end of a bit string which composes a character.
Select an appropriate value depending on the requirements of the printer or personal computer.
Value Range
1 bit, 2 bit
19.1 PBX Configuration—[11-1] Maintenance—Main
PC Programming Manual 777