Panasonic KX-NS1000 Pc Programming Manual page 310

9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
Value Range
1024–65024
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
Keep Alive Time-Out
Specifies the length of time that the PBX will continue to consider an IP-CS to be active even if it receives no
transmissions from that IP-CS. The PBX constantly confirms the status of IP-CSs. If no communications are
received from an IP-CS for the duration specified here, the PBX considers the IP-CS to be unreachable, and
sets the port status to Fault.
During operation, set between 10 s and 60 s. Settings over 60 s, and Disable, are used for debugging purposes,
and IP-CSs cannot be guaranteed to function normally in these circumstances. Do not use debugging settings
unless instructed to do so.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
Disable, 10–120 s
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
First Resending Time (PTAP)
Specifies the length of time that the PBX waits before starting to resend PTAP (Panasonic Telephony
Administration Protocol) data.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
500 ´ n (n=1–16) ms
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
Resending Time Out (PTAP)
Specifies the length of time after which the PBX terminates resending PTAP (Panasonic Telephony
Administration Protocol) data.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
150–240 s
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
310 PC Programming Manual