Panasonic KX-NS1000 Pc Programming Manual page 912

24.4 UM Configuration—[5-4] System Parameters—Parameters
to "EFA Transfer Sequence" specified in "Transfer to Outside". If set to "Disable", the system transfers incoming
trunks calls to another trunk according to
Sequence (Up to 16 digits / [0-9 * # D F R T , ; N]) specified in Transfer to Outside.
Value Range
Enable, Disable
Maintenance Console Location
24.4 UM Configuration—[5-4] System Parameters—Parameters
Trunk Group (1–96)—Caller ID Callback
Specifies whether or not the system allows a subscriber to call back the party who left a message in his or her
mailbox by using the caller ID information sent from the PBX. This setting applies to the trunk number used
when the message with Caller ID information was left in his or her mailbox.
Value Range
Enable, Disable
Maintenance Console Location
24.4 UM Configuration—[5-4] System Parameters—Parameters
Trunk Group (1–96)—Outside Line Access Sequence for Caller ID Callback (Up
to 16 digits / [0-9 * # D F R T , ; ])
Specifies the sequence of trunk access numbers for Caller ID Callback. This parameter is available when the
system executes Caller ID Callback without using EFA.
Value Range
Max. 16 digits consisting of 0–9,
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause for 1 s (default)
; : Dial Pause for 3 s (default)
0–9, , #: Dial Code
Maintenance Console Location
24.4 UM Configuration—[5-4] System Parameters—Parameters
Number of Digits in Telephone Number (1-20)
Specifies the number of digits for local area telephone numbers. According to this parameter, telephone
numbers dialled by the system can be distinguished as either local calls or long distance calls.
Value Range
1–20
912 PC Programming Manual
Outside Transfer Sequence—Call Transfer to Outside
, # and special codes