Panasonic KX-NS1000 Pc Programming Manual page 763

PC Programming Manual References
9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - BRI Port
Feature Guide References
2.1.1.4 Multiple Subscriber Number (MSN) Ringing Service
VM Trunk Group No.
Specifies the number of the VM trunk group sent to the VPS when the incoming call destination is the floating
extension number of a VM (DPT) Group (connected to a KX-NCP/KX-TDE series PBX). The VM trunk group
number is used to allow the VPS to send the applicable greeting message to the caller.
Value Range
1–48
Maintenance Console Location
18.4 PBX Configuration—[10-4] CO & Incoming Call—MSN Table
CLI for MSN
When CLI distribution is enabled for an ISDN-BRI line to which MSN distribution is set, incoming trunk calls
will be distributed to the CLI destinations (instead of the MSN destinations) if the caller's identification number
is found in the System Speed Dialling Table.
CLI distribution can be enabled or disabled for each time mode (day/lunch/break/night) on a trunk basis.
Site
Indicates the site number of the PBX in the One-look network (reference only).
Value Range
1– 16
Maintenance Console Location
18.4 PBX Configuration—[10-4] CO & Incoming Call—MSN Table
Shelf
Indicates the shelf type and/or position (reference only).
Value Range
1 (Physical), Virtual
Maintenance Console Location
18.4 PBX Configuration—[10-4] CO & Incoming Call—MSN Table
18.4 PBX Configuration—[10-4] CO & Incoming Call—MSN Table
PC Programming Manual 763