Panasonic KX-NS1000 Pc Programming Manual page 178

9.1 PBX Configuration—[1-1] Configuration—Slot
8.
Click OK to complete pre-installation.
You can now click the Legacy-GW1 or Legacy-GW2 shelf buttons to programme the cards of the legacy
gateways.
Note
•
If Pre-Install is not displayed as described in step 5, pre-installation has already been completed. Click
Legacy-GW1 or Legacy-GW2 on the slot screen to programme the PBXs connected to the
STACK-M card.
•
For information about hardware configuration restrictions and conditions for legacy gateways, refer to
Conditions for Connecting Legacy Gateways in 4.6 Stacking Cards in the KX-NS1000 Installation
Manual.
Supported Card Types
Card
LCOT2+SLC2: A combination card
including:
•
2 analogue trunk ports
•
2 extension ports for SLTs
BRI4+SLC2: A combination card
including:
•
4 ISDN Basic Rate Interface ports
•
2 extension ports for SLTs
PRI30+SLC2: A combination card
including:
•
1 ISDN Primary Rate Interface port
(30B channels).
•
2 extension ports for SLTs
PRI23+SLC2: A combination card
including:
•
1 ISDN Primary Rate Interface port
(23B channels).
•
2 extension ports for SLTs
STACK-M: Stacking Master Card for
connecting PBXs as legacy gateways.
V-IPEXT32: Virtual 32-Channel VoIP
Extension Card
V-SIPEXT32: Virtual 32-Channel SIP
Extension Card
V-UTEXT32: Virtual 32-Channel SIP
Proprietary Telephone Card
V-IPGW16: Virtual 16-Channel VoIP
Gateway Card
178 PC Programming Manual
Maximum Number/PBX
1
4
20
20
3
Card Programming
LCOT2:
9.24 PBX Configuration—[1-1]
Configuration—Slot—Card Property
- LCO type
SLC2:
9.22 PBX Configuration—[1-1]
Configuration—Slot— SLC2 - Card
Property
BRI/PRI:
9.26 PBX Configuration—[1-1]
Configuration—Slot—Card Property
- BRI type/PRI type
STACK-M:
9.29 PBX Configuration—[1-1]
Configuration—Slot—Legacy-GW1/
Legacy-GW2
9.14 PBX Configuration—[1-1]
Configuration—Slot—V-IPEXT32—
Card Property
9.16 PBX Configuration—[1-1]
Configuration—Slot—V-SIPEXT32
—Card Property
9.20 PBX Configuration—[1-1]
Configuration—Slot—V-UTEXT32
—Card Property
9.12 PBX Configuration—[1-1]
Configuration—Slot—V-IPGW16—
Shelf Property