Panasonic KX-NS1000 Pc Programming Manual page 364

9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - BRI Port
Value Range
En-bloc: The PBX sends all of the dialled digits at once after the extension user completes dialling. The PBX
recognises the end of dialling when (1) # is dialled, if programmed, (2) a pre-programmed telephone number
is dialled, or (3) the inter-digit timer expires.
Overlap: The PBX sends dialled digits one at a time.
Maintenance Console Location
9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - BRI Port
PC Programming Manual References
9.1 PBX Configuration—[1-1] Configuration—Slot
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone—
Inter-digit
10.9 PBX Configuration—[2-9] System—System Options—Option 2—
Dial for en Bloc mode
11.1.4 PBX Configuration—[3-1-4] Group—Trunk Group—Dialling Plan
Feature Guide References
4.1.2.1 Integrated Services Digital Network (ISDN)—SUMMARY
ISDN Centrex
Enables the use of the telephone company's ISDN Centrex Service features.
Value Range
Disable, Enable
Maintenance Console Location
9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - BRI Port
Feature Guide References
4.1.2.1 Integrated Services Digital Network (ISDN)—SUMMARY
BRI Data Link (P-MP) Mode
Assigns one or two TEIs (Terminal Endpoint Identifier) to the BRI CO port. To use the ISDN Hold supplementary
service with point-to-multipoint configuration, this parameter should be set to 2-link in some countries/areas.
Value Range
1-link: One TEI is assigned to the BRI CO port.
2-link: Two TEIs are assigned to the BRI CO port. (Available when
to P-MP.)
364 PC Programming Manual
ISDN en Bloc Dial—[#] as End of
Access Mode on the Network tab is set
Dial—Extension