Cycle Alarms And Messages; Error Handling In The Cycles; Overview Of Cycle Alarms - Siemens SINUMERIK 840D Operation/Programming Manual

8
Alarms and Messages

8.1 Cycle alarms and messages

8.1

Cycle alarms and messages

8.1.1 Error handling in the cycles

8.1.2 Overview of cycle alarms

Alarm number
61000
61001
61002
61003
61006
61007
61009
61010
61011
61012
61013
61101
8-398
If error conditions are detected in the cycles, an alarm is output and
processing is aborted.
Alarms with numbers between 61000 and 62999 are output in the
cycles.
The reset criteria for these number ranges are
• 61000 ... 61999 is NC-RESET
• 62000 ... 62999 is CANCEL
The text displayed with the alarm number provides an explanation of
the cause of the error.
The following table lists the alarms that might occur in the cycles with tips on how
to remedy the errors that cause them.
Alarm text
"No tool offset active"
"Thread pitch incorrectly defined" Check parameters for thread size and check
"Machining type incorrectly
defined"
"No feedrate programmed in cycle"The parameter for feedrate has been incorrectly
"Tool radius too large"
"Tool radius too small"
"Active tool number = 0"
"Finishing allowance too large"
"Invalid scaling"
"Different scales in one plane"
"Basic settings have been altered,
program cannot be executed"
"Reference plane incorrectly
defined"
Explanation, remedy
D-correction must be programmed before the
cycle call
pitch information (contradict each other)
The machining type parameter has been set to
the wrong value and needs to be altered.
set and must be altered.
Select smaller tool
Select larger tool
Load the required tool
Reduce the finishing allowance setting
The active scaling factor is not permissible for
this cycle.
Cycle execution only possible with uniform
scaling in the plane
Check and, if necessary, change the basic
settings
Either different values must be entered for the
reference plane and the retraction plane if they
are relative values or an absolute value must
be entered for the depth
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
8
10.04
 Siemens AG, 2004. All rights reserved