Configuring Mirage Sst To Work With Christie Link; Disposing Of The Product Packaging - Christie Mirage SST Installation And Setup Manual

• Test patterns are turned off (on page 49).
• The active signal is valid.
2. From the remote, select Auto Signal or from the web UI, select Auto Setup.
3. Select Run Auto Setup.
The system optimizes the active signal and displays a progress message on screen.
Configuring Mirage SST to work with Christie
Link
Configure Mirage SST to work with Christie Link, which provides a fully integrated fiber solution for
long range video transport.
1. Turn on Mirage SST.
2. Verify the HBMIC has been installed in slot 0.
3. To enable the Christie Link option, select MENU > Configuration > Input Settings >
Enable Christie Link (Slot 0).
This option is disabled if an HBMIC is not installed.
4. Select Enter.
5. Select the QSFP+ option as the input setting.
a) From the side panel home page, select Input.
b) On the Input selection page, select the appropriate input marked Christie Link.
More than one input source may be listed as Christie Link, depending on how many
signals are being sent from Christie Link. For example, 0-1, 0-2, and so on, where 0 is the
slot number.
Related information
Performing initial system start-up (on page 40)
Turning on the system (on page 42)

Disposing of the product packaging

Once the product has been installed and set up, Christie recommends reusing or recycling the product
packaging according to your local regulations.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
57