Remove The Projector Shroud - Christie Mirage 4K35 User Manual

Add an extractor or a booster if there is insufficient airflow. Do not mount the extractor on the
projector as this may introduce some vibration into the image.
Notice. Failure to comply with the following may result in property damage.
Never disable the vane switch. Attempting to operate the projector with inadequate airflow
can result in dangerous overheating of the projector.
To prevent the projector from overheating or becoming unsafe, an alarm sounds if the duct
i
is obstructed or a fan fails. Christie recommends regularly verifying that the exhaust is
unobstructed and functioning correctly.

Remove the projector shroud

Warning! Failure to comply with the following could result in death or serious injury.
• Never install the shroud for overhead installations.
The lens side shroud must be removed to gain access to the lens. The other shroud must be
removed when connecting the AC power cord into the front face of the projector.
1. Use finger pressure to push down on the shroud clips located at the top and bottom of the
shroud as shown by the arrows.
2. Carefully slide the shroud sideways and forward away from the lens mount and lens.
3. Place the shroud covers on a clean surface to prevent scratches.
Mirage 4K35 User Manual
020-101377-03 Rev. 1 (07-2015)
1
2
Installation and Setup
34