IBM X3950 X5 Problem Determination And Service Manual page 428

80070608-0a02ffff • 80070608-1401ffff
80070608-0a02ffff Sensor [SensorElementName] has transitioned to non-recoverable.
Explanation: IMM has detected Power Supply related fault. (PS 12V OC Fault, PS 12V OV Fault, PS 12V UV Fault,
or PS AUX UV Fault)
May also be shown as 800706080a02ffff or 0x800706080a02ffff
Severity: Error
Alert Category: Critical
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0530
SNMP Trap ID: 4
Automatically notify Support: No
User response:
1. Check the power supply LEDs, see "Power-supply LEDs".
2. Replace the failing power supply.
80070608-1401ffff Sensor [SensorElementName] has transitioned to non-recoverable.
Explanation: A system power fault has occurred.
May also be shown as 800706081401ffff or 0x800706081401ffff
Severity: Error
Alert Category: Critical
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0530
SNMP Trap ID: 4
Automatically notify Support: No
User response:
1. Critical: Do Not attempt to power the system on, or AC cycle. Do so only when instructed to in the following
steps.
2. 1. Using the IMM web interface, determine the version of FPGA installed and capture an IMM log for support
reference.
3. Perform the following actions for the FPGA version installed.
4. [FPGA versions lower than 4.00]
5. 2. Remove AC power.
6. 3. Remove memory card identified and check for connector pin damage on memory card and CPU memory
card slot.
7. a) Replace affected commodity if damage is found.
8. 4. Swap the memory card in the slot identified, with a memory card from another slot with the same
configuration of DIMMs (size, type, number)
9. 5. Restart the server and see if problem still identifies the same memory card slot.
10. a) If problem remains with original slot, replace the I/O board assembly.
b) If problem occurs in slot where original memory card was moved to, replace the memory card.
11.
[FPGA versions 4.00 and 4.01]
12.
13. 2. If local, pull out the Operator Information Panel, observe and make note of what is being displayed on the
Checkpoint display for support reference.
14. 3. Using the IMM web interface, capture a 'Service Data' file if available (note:) for support reference.
15. 4. Remove AC power.
412
IBM System x3850 X5 and x3950 X5 Types 7145, 7146, 7143, and 7191: Problem Determination and Service Guide