Setup Utility Menu Choices - IBM X3950 X5 Problem Determination And Service Manual

For more information, see "Using the remote presence capability and blue-screen
capture" on page 215
v Ethernet controller configuration
For information about configuring the Ethernet controller, see "Configuring the
Broadcom Gigabit Ethernet controller" on page 216.
v IBM Advanced Settings Utility (ASU) program
Use this program as an alternative to the Setup utility for modifying UEFI
settings and IMM settings. Use the ASU program online or out of band to
modify UEFI settings from the command line without the need to restart the
server to run the Setup utility. For information about using this program, see
"IBM Advanced Settings Utility program" on page 217.

Setup utility menu choices

This topic provides descriptions of the Setup utility menu choices.
The following choices are on the Setup utility main menu. Depending on the
version of the IBM UEFI firmware, some menu choices might differ slightly from
these descriptions.
v System Information
Select this choice to view information about the server. When you make changes
through other choices in the Setup utility, some of those changes are reflected in
the system information; you cannot change settings directly in the system
information.
This choice is on the full Setup utility menu only.
– System Summary
Select this choice to view configuration information, including the ID, speed,
and cache size of the microprocessors; machine type and model of the server;
the serial number; the system UUID; and the amount of installed memory.
When you make configuration changes through other choices in the Setup
utility, the changes are reflected in the system summary; you cannot change
settings directly in the system summary.
– Product Data
Select this choice to view the system-board identifier and the revision level or
issue date of the server firmware, integrated management module, and
diagnostics code.
v System Settings
Select this choice to view or change the server component settings. This choice is
on the full Setup utility menu only.
– Adapters and UEFI Drivers
Select this choice to view information about the adapters and device drivers
in the server that are compliant with EFI 1.10 and UEFI 2.0.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings. To configure
memory mirroring, select System Settings → Memory →Memory Mirroring
Mode → Mirrored.
Chapter 6. Configuration information and instructions
203