IBM X3950 X5 Problem Determination And Service Manual page 165

Replacing the RAID adapter carrier and the RAID adapter
assembly
This topic provides steps to replace the RAID adapter carrier and RAID adapter
assembly.
About this task
To replace the RAID adapter carrier and RAID adapter assembly, complete the
following steps:
Procedure
1. If you removed a battery carrier and battery from the former RAID adapter, use
the three screws and install it on the new RAID adapter.
2. Install the replacement RAID adapter onto the RAID adapter carrier.
Post
Tabs
3. Connect the SAS cables to the RAID adapter.
Note: Attach the SAS cable from port 0 to the lower backplane and the SAS
cable from port 1 to the upper backplane (if one is installed).
ServeRAID M5015 controller
Port 1 Port 0
Release
latch
Chapter 5. Removing and replacing components
149