IBM X3950 X5 Problem Determination And Service Manual page 140

Removing a hot-swap power supply in a single-node server:
About this task
To remove a hot-swap power supply in a single-node server, complete the
following steps.
Power supply
handle release
latch
Procedure
1. Read the safety information that begins with "Safety" on page v and
2. If only one power supply is installed, turn off the server.
3. Disconnect the power cord from the connector on the back of the power supply.
4. Slide the orange release latch on the handle to the right and lift the handle up
5. Pull the power supply out of the bay.
6. If you are instructed to return the hot-swap power supply, follow all packaging
124
IBM System x3850 X5 and x3950 X5 Types 7145, 7146, 7143, and 7191: Problem Determination and Service Guide
Power supply
Power supply
handle
"Installation guidelines" on page 97
Note: If your server has only one power supply, you must turn off the server
before you remove the power supply.
to the open position.
instructions, and use any packaging materials for shipping that are supplied to
you.