Optipoint Interface - Siemens HiPath 1100 Service Manual

7.2.1.4

optiPoint Interface

optiPoint 500 telephones that feature a USB Interface (Advance, Basic/Standard/Economy,
Entry) can be used as a USB interface for performing administrative tasks.
In this case there are two ways to connect via optiPoint: VCOM or CAPI.
a) Connections via optiPoint VCOM: Up to 8 optiPoint telephones can be connected to
the system at the same time, although at lower speeds.
For this type of connection you can install the USB Administration drivers or USB
Administration + CAPI interface drivers
b) Connections via optiPoint CAPI: This connection via optiPoint is up to four times faster
than an optiPoint VCOM connection (item a), therefore only one administration
connection may be made each time. No other administration connections via optiPoint
CAPI or remote ISDN connections to the system will be made while there is a CAPI
connection running.
USB administration + CAPI interface drivers must be installed for this type of
connection.
Figure 7-5 Possible optiPoint Configurations
Service Manual
HiPath 1100 Applications
Manager Software
Billing
CommServer
CallBridge
for Data
USB
UP0/E
HiPath
1100
Maximum number of interface
connections - 8
System programming mode using a PC
Possible USB
Configurations
Transmission
Status Monitor
optiPoint telephones
Operation
7-287