Siemens HiPath 1100 Service Manual page 249

The Data (Fax/Modem) option uses the same dial tones and call sequence as the public network to avoid problems in detect-
ing pauses, internal dial tones and/or duplicate calls. In addition, the override and call waiting functions are blocked in order to
prevent transmission faults.
When connecting a fax device, no additional settings (such as Fax Detection)
>
need to be configured.
The Answering machine option requires the same configuration as in "Data (Fax/Modem)". However, you can answer calls if
Auto-Answering is activated.
The External entrance telephone option supports up to 4 devices connected directly to analog ports A/B or in the bar of the
S module, as follows:
0
The external analog entrance telephone device must behave like an analog telephone
●
(dialing, detection and DTMF control)
The ISDN external entrance telephone device must behave like an ISDN telephone. It
●
must also be controlled by DTMF signals.
Consult the external entrance telephone manual to check available settings.
>
Go to the HiPath 1100 Manager folder - Advanced/System Settings/General -
"External entrance telephone" and insert the information on the entrance tele-
phone device for correct working.
Auto-Answering Mode (034)
This setting specifies the use of the Auto-Answering Mode for the telephone by using a feature code (see Functions used for
Making Calls - Speakerphone Auto-Answering Mode in the User Manual).
Pulses for call charges on an analog extension (041)
This sends pulses to be charged for calls on an analog extension (12kHz/16kHz). With this feature, an extension's telephone
set can display the number of pulses or the amount charged for the call.
Please refer to the documentation provided with the telephone set connected to the
extension to find out if a billing indication is supported and which transmission mode
is used.
Service Manual
Configuring the system specifically for the client
Comments about the system's programming codes
6-249