Siemens HiPath 1100 Service Manual page 266

Configuring the system specifically for the client
Comments about the system's programming codes
CommServer does not work when this setting is enabled.
Ticket Cost Code Ticket (095)
External calls can be assigned Cost Codes which provide more control over telephony costs. This information may be present-
ed on the billing ticket. This Cost Code is defined by the user and is made up of a sequence of up to 10 random digits (0...9)
which could be, for example, the number of a legal process (see Functions Used During a Call - Cost Code, in the User Manual).
If Cost Codes have not been configured in advance using the HiPath 1100 Manager (See Cost Codes - A31003-K1270-M100-
*), only ten-digit cost codes will be accepted in analog and S
Baud Rate (120)
The system can be connected to a PC or printer with a V.24 adapter to display or print the call detail report. The communication
speed can be set to ensure proper data transfer.
Digit Suppression in CDR Record (121)
This setting specifies how many end digits can be omitted in the data output when dialing a call on an external line. These
digits will be replaced by "?."
Call detail report for incoming calls (161)
When this option is selected, call details are shown in the CDR record.
For the system to receive Caller ID information over digital, E1 CAS/S2 or analog
lines the Caller ID feature must be enabled by a local carrier.
The Caller ID service must be contracted with a local carrier.
Call Detail Report Filter (167)
The number programmed in this filter specifies the type of outgoing call to be recorded, based on the first four digits of the
dialed number.
For example, in order to record only outgoing international calls you must program the digits "00." The maximum number of
digits is 4.
In the default setting a digit sequence is not configured.
Cost Code type (243)
Inputting the Cost Code when making an external call can be "mandatory" or "optional", depending on the way the code is con-
figured.
Optional - There is no need to type in the Cost Code at the start of the call in order to
●
complete the call. However, it can be typed in during the call if you are using a system
telephone.
6-266
telephones. Otherwise, the call will not be completed.
0
Service Manual