Figure 7-71 Access To Comgate - Siemens HiPath 1100 Service Manual

Operation
HiPath 1100 applications
The default connection configuration of the application of the new ADSL module is configured
for HiPath V7.0. To use COMGATE mode, configure the new ADSL module using the following
link: >>Network<<->>HiPath<<.
Figure 7-71 Access to COMGATE
Through this link you can verify the current configuration and change it for versions 5.2 or 6.0
by clicking >>Change<<.
Press >>Save & Reboot<< and the system will restart in COMGATE mode. Configuration in
the web interface works in the same way as explained above. Only the connection with the
HiPath 1100 will be made using the CommServer and will use the IP addresses defined in the
web interface and the port.
7-348
Service Manual